Skip to main content

FAQ - Getting Started with the iHealth Push (KD-723)

Updated

Product Overview

Screenshot 2025-02-28 at 10.20.03 AM.png

iHealth Push Wrist Blood Pressure Monitor is for use by medical professionals or by individuals (patients) at home. It is a non-invasive blood pressure measurement system intended to measure the diastolic blood pressure, systolic blood pressure and pulse rate of an adult individual by using a non-invasive technique in which an inflatable cuff is wrapped around the wrist. The cuff circumference is limited to 5.5-7.7 in (14.0-19.5 cm).

 

BOX CONTENTS

  • Wrist Blood Pressure Monitor
  • Carrying Case
  • 2 1.5V AAA Batteries
  • Instruction Manual

CONTRAINDICATION

Screenshot 2025-02-19 at 3.57.40 PM.png This Blood pressure monitor (Electronic Sphygmomanometer) is not suitable for people with severe arrhythmia to use.

 

Installation

  1. Install the batteries with the correct polarity.
  2. Open the iHealth MyVitals app and log in to your account or create an account. The iHealth MyVitals app can be downloaded free from the App Store and Play Store.
  3. Make sure Bluetooth is activated on your smartphone.
  4. Go to: Screenshot_20250121-152909.png > Select Blood Pressure Monitors > Select Push KD-723 
  5. Press the Memory M button on the blood pressure monitor and press Next in the application.
  6. The application will search for an iHealth Push blood pressure monitor nearby. Select the blood pressure monitor that you wish to pair with your account.

mceclip0.png

The date and time of the iHealth Push are updated with the date and time of your smartphone. Everything is ready! Give it a try, and take a measurement.

 

Note- The iHealth Push blood pressure monitor is a connected blood pressure monitor but can also be used without ever connecting it to a smartphone. In this case, you must manually set the date and time to time-stamp your measurements.

 

Manually setting the date and time

For unconnected use of the iHealth Push blood pressure monitor, here is how to manually set the date and time.

  1. Press and hold the START/STOP and Memory M buttons for 3 seconds to enter the date and time in the settings. The time format is displayed (24H or 12H). 
    mceclip0.png
  2. Press the Memory M button to change the time format.
  3. Press the START/STOP button to confirm and go to the following settings: Year, Month, Day, Hour, Minutes. 
    mceclip5.png
  4. At each step, press the Memory M button to increment the values and on the START/STOP button to confirm and go to the next setting.
  5. After setting the minutes, pressing the START/STOP button again lets you exit the date and time setting mode.

 

 

Related articles