INTENDED USE
The product is intended to provide temporary relief of the pain and itching resulting from insect stings
and bites.
TARGET GROUP
The insect bite healer is intended for home use only. It should be used with adult supervision on those aged 3-11. Individuals aged 12+ may operate the device independently.
CONTRAINDICATIONS
1. Do not use the device on damaged or irritated skin (e.g., skin with ulcers, burns, frostbite, bruises, eczema, or swelling from causes other than insect bites).
2. Do not use the device on patients with diabetes, peripheral neuropathy, or other conditions that
impair sensory perception.
3. Do not use the device while experiencing a fever.
4. Do not use the device on mucous membranes or sensitive areas.
5. Do not use the device in combination with topical medications or cosmetics.
PARTS AND CONTROLS
SETUP AND OPERATION
LOADING BATTERIES
a. Open the battery cover (7) at the back of the device.
b. Insert two AAA batteries according to the positive and negative marks (+ and -) stamped on the battery box.
c. Reattach the battery cover to the device.
Battery Tips:
Replace batteries when the left, middle, and right lights light up in sequence and repeat.
- Do not use rechargeable batteries.
- Avoid getting battery fluid in your eyes. If it does get in your eyes, immediately rinse with plenty of clean water and contact a doctor.
- The negative terminal of the battery needs to be properly seated into the battery compartment after compressing the spring. The battery must contact the spring.
- The device,the batteries must be disposed of according to local regulations at the end of their life.
USING YOUR INSECT BITE HEALER
Before using the device, make sure there is no insect stinger remaining in the affected area. Gently remove any stinger prior to application. For the best results, use the device immediately after an insect bite or sting. While delayed use may reduce its effectiveness—especially if itching or swelling has already developed—it is still recommended, as the device can help alleviate discomfort and support the healing process
-
Slide the power switch (5) to
(the middle setting) to power on or to
(the top
setting) to turn on both the device and the flashlight. The indicator lights (1) will flash for the corresponding mode. - Press the Mode button
(2) to select a heat level: the left light illuminates for Low, the left and middle lights illuminate for Medium, and all lights illuminate for High.
- Place the heating plate (4) of the device directly on the bite/sting area.
- Press the START button (3) to begin treatment. After a beep, the heating plate will begin heating and last for 6s.
- After the selected treatment is over, a beep will signal completion and the heating plate will automatically stop heating. Remove the heating plate from the skin. This heat level will be recorded.
-
Slide the switch (5)
to to power off the device. (The device will also power off
automatically after 1 minute of inactivity.) - Before storing, make sure that the device is powered off and the heating plate has cooled down.
- You can slide the switch (5)
Note: Depending on the sensitivity of the individual using the device and the area of skin being treated, the therapeutic temperature may feel uncomfortable and could result in mild skin redness or, in rare instances, skin irritation. Should the heat function feel excessively hot, discontinue
iHealth Customer Service
iHealth Customer Service Can be reached via phone at 1-855-816-7705 (Monday-Friday 8:30am to 5:30 PM PT) or via email at support@ihealthlabs.com. Self Help can be obtained 24 hours at the Help Center.